VeEX MPA User Manual page 523

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
523
•
2.5 Gbps opt @ FDX
•
1 Gbps opt @ FDX
•
1 Gbps elec @ FDX
•
100 Mbps opt @ FDX
•
100 Mbps elec @ FDX
•
10 Mbps elec @ FDX
The MPM-100AR and MPM-10G cards also support 10
Gbps opt LAN in OTN by selecting OTU1e (11.049G) or
OTU2e (11.095G) from the OTN tab's Interface menu.
Available interface rates and mappings are dependent on
the licensed-based test options currently enabled.
All currently licensed interface rates are displayed in the
Interface menu, regardless if the rates are actually supported
by the currently inserted laser modules or not. Verify that the
inserted laser module supports the desired Interface rate
prior to selecting it.
The Packet processor supports hot-swappable laser
modules.
The wavelength of the selected interface is determined by
the specifications of the pluggable laser module being used.
Electrical Ethernet rates require an Electrical RJ-45 SFP
module.
Constant LOS or Link State alarms may be present when
an unsupported Interface rate or mapping selected or if the
required laser module is unplugged.
Not Assigned is displayed if one of the Interfaces listed
above is currently not selected.
When OC-192 or STM-64 is configure for Ethernet WAN
mapping, then the Mode setting will display 10 Gbps opt
WAN.
When SONET, SDH or OTN are configured for GFP
payload mapping, then the Mode menu will also contain GFP