VeEX MPA User Manual page 93

MPA_e_manual_D07-00-129P_RevA00
MPA Chassis
When inserting a new module into the MPA chassis, verify the module is oriented
correctly and the printed circuit board is properly aligned with the guide rails.
Notice the orientation of the module's printed circuit board in the image above.
Push on the front of the card until it contacts the backplane socket, then push even
harder on the front of the card with the appropriate amount pressure to fully seat the
card's connector into the socket.
When the module is fully seated, the faceplate will be flush with the other faceplates
in the system.
93