VeEX MPA User Manual page 770

MPA_e_manual_D07-00-129P_RevA00
Specify an IP address: Allows a static IP Address to be entered including the IP
Address, Subnet Address, Router, and DNS addresses.
Obtain an IP address from a DHCP server: The unit will uses the network's Dynamic
Host Connection Protocol (DHCP) server to dynamically assign it an IP address.
When DHCP is selected, the IP Address, Subnet Address, Router, Host
Name, Domain Name, and DNS Address functions are disabled and populated
by the DHCP server after being rebooted
Only choose Obtain an IP Address from DHCP if know how to retrieve the
new IP Address automatically assigned from the DHCP server, or your MPA has
an SCM-210 card which displays the obtained IP address.
•
IP Address: Enter the unit's IP Address using dotted decimal notation. For
example, nnn.nnn.nnn.nnn, where nnn is a value from 0 to 255.
IP addresses 192.168.138.0 through 192.168.138.255 are reserved and
should not be used. A serious system conflict can occur if an IP address in
this range is assigned to the processor.
If you use an IP address in the range of 192.168.x.y (where x is not 138), then
you must set the Subnet Address to 255.255.255.0.
•
Subnet Address: Enter the Subnet Mask Address using dotted decimal notation.
•
Router: Enter the Router/Gateway Address using dotted decimal notation.
•
DNS Address 1 & 2: The DNS Addresses should only be modified if specific
DNS Addresses need to be entered for your network, otherwise the default DNS
Addresses do not need to be changed.
•
By default, the DNS Address 1 (Primary DNS) is configured for 8.8.8.8,
and the DNS Address 2 (Secondary DNS) is configured for 8.8.4.4.
These are public DNS addresses established by Google, and only need to
be modified if being replacing with a network-specific addresses.
When specifying an IP Address, the Host Name and Domain Name parameters
are preset to "localhost".
TCP Ports required
In order to fully utilize the MPA system, the MPA system needs access to the following
TCP Ports through your personal or corporate firewall.
TCP
Port
Application
IO Settings Screen
770