VeEX MPA User Manual page 540

MPA_e_manual_D07-00-129P_RevA00
Flag (IPv4)
Flow Label (IPv6)
Rate
Burst Size
Sets IPv6's IP Flow Label. This is a decimal value from 0 to
1048575.
Sets the traffic generation rate for the selected Stream.
Rates can be configured as:
•
Constant %Bandwidth (0.01 to 100%)
•
Constant Mbit/sec (0.1 to max Mb/s, for the selected
Interface)
•
Constant IPG-Byte
•
Constant IPG-MS
•
Ramp %Bandwidth
•
Ramp Mbit/sec
Constant IPG rates control the bandwidth by configuring the
size of the InterPacket Gap between packets, in either Bytes or
Milliseconds.
Configures the number of packets to be inserted in each Burst.
This setting applies to both the traffic generation rates, and the
Send Burst button.
The Send Burst button will generate a single burst of packets,
for the specified amount of packets.
The default Burst size is 1 frame, and should be set to 1
frame when not intentionally generating bursty traffic, to allow
the inner-packet gaps (IPG's) to be evenly distributed.
Any value greater than 1 will result in the packets being
generated as bursts of packet, with minimal IPG's between the
Packet Tab
540