Copyright - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
Avoid Electric Overload: This unit is designed to be powered from 110-265VAC
(auto-range), 50–60 Hz, 600 Watts. To avoid electric shock, fire hazard, or
damage to the instrument, do not apply a higher voltage.
Ground the Instrument: The unit is grounded through the grounding conductor of
the power cord. To avoid electric shock, the grounding conductor must be
connected to earth ground. Before making connections to the input or output
terminals of the instrument, ensure that the product is properly grounded.
For the -48v DC supply module:
Turn off the unit's power switch when making power input connections.
This product is intended to operate from a -48 VDC, 420 Watt, source derived
from batteries, SELV, or an NEC Class II device.
Verify that the input power requirements (-42 VDC to -56 VDC) are met before
installing the unit.
The DC Power supply is designed for redundant power sources, with dual-
input 7W2 D-Sub connector receptacles.
Ground the Instrument: To avoid electric shock using a DC power supply,
ensure that the chassis is properly grounded to earth ground using the ground
connector on the rear of the chassis, before making input power connections to
the device.

Copyright

Copyright © VeEX Inc. - All rights reserved.
VeEX reserves the right to revise and improve this document, as well as the contents of
this document as it sees fit. This publication describes the state of this product at the
time of its publication and may not represent the product at all times in the future.
For conditions of use and permission to use these materials for publication in other than
the English language, contact VeEX Inc.
General Information
14