VeEX MPA User Manual page 717

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
# Of Repetitions
Statistics Table
Start/Stop Test
Important: The BW Ceiling and BW Floor settings do not apply to the Back-to-Back
Burst test.
The following list of tasks demonstrate how to configure and test each of the RFC-
2544 benchmark tests.
•
To Configure the RFC-2544 test settings see
•
To run an RFC-2544 Thru Put test see
•
To run an RFC-2544 Frame Loss test see
•
To run an RFC-2544 B2B Burst test see
Results
Results Screens and Functions
(Specifically for GFP Mappings)
Test activity and event history can be viewed using the various functions of the Results
screen.
The Results screen contains the following functions:
717
are 1-812.
Enter the number of times the trial length should be repeated.
The RFC recommended repetition is 50, however valid
values are 1-100.
Reports the test results. The system recovery results are
displayed by Frame Size (bytes) tested as follows:
•
Max Possible Number of Frames - The frame rate
(resolution) used as the throughput rate.
•
Avg Observed B2B Frames - Average frame count for
each type of data stream tested.
Starts and stops the Back-to-Back Burst test. The button
toggles between Start (when a test is not running) and Stop
(when a test is running).
What are RFC 2544 Tests?
Throughput Testing
Frame Loss Testing
Back-to-Back Burst Testing