VeEX MPA User Manual page 559

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Restore to
Default
Perf Dur
Service On/Off
559
Returns the Ramp/Burst Step settings to their default %CIR
rates when user-defined rates have been set, and unselects all
selected checkboxes, and resets the Trial and Performance
Durations back to their default values.
Any user-define Service Names which were edited from the
Test side tab are also restored back to their default names.
Determines how long the Performance test runs for each
selected Service.
"Perf Dur" refers to Performance test duration, and "Trial
Duration" refers to Configuration test duration
The Y.1564 test standard calls for test durations of 15
minute, 2 hour, and 24 hour intervals. "For example, an
operator MAY test services for 15 minutes if the services are
provided over a network already carrying working traffic in a
metro application. 2 hour Performance test durations MAY be
used for services running over a single operator long-haul
network. Finally, a 24 hour Performance test durations MAY be
used for services which are being carried internationally over
multiple operator networks".
Allows the user to select one of the ten Services that will be
used for the Y.1564 test.
Each of the Service's Configuration Test settings can be
edited in the Test side tab.
Each Service selected to be tested should be configured for
an increasing number of Frame Lengths, as shown in Table 1.
Service #
Service 01
Service 02
Service 03
Service 04
Service 05
Service 06
Service 07
Service 08
Frame Size (bytes)
64
128
256
512
1024
1280
1518
MTU