VeEX MPA User Manual page 211

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
•
A/D TCM #1 Alarm Reporting (Tandem Connection Monitoring #1) - Enabled
with or without TIM Alarm Reporting
•
A/D TCM #2 Alarm Reporting (Tandem Connection Monitoring #2) - Enabled
with or without TIM Alarm Reporting
•
A/D TCM #3 Alarm Reporting (Tandem Connection Monitoring #3) - Enabled
with or without TIM Alarm Reporting
•
A/D TCM #4 Alarm Reporting (Tandem Connection Monitoring #4) - Enabled
with or without TIM Alarm Reporting
•
A/D TCM #5 Alarm Reporting (Tandem Connection Monitoring #5) - Enabled
with or without TIM Alarm Reporting
•
A/D TCM #6 Alarm Reporting (Tandem Connection Monitoring #6) - Enabled
with or without TIM Alarm Reporting
•
A/D OPU PLM Alarm Reporting (Payload Label Mismatch) - Enabled or Disable
Alarm Reporting
•
A/D OPU Out of Frequency Threshold - Sets the threshold (in ppm) for which
the Add/Drop OPU:Frequency Wide alarm occurs, based on the measured A/D
OPU Justify Frequency Offset. The default value is 0.0 (Disabled).
These settings are only available when the OTN Interface is configured for an ODTU
Add/Drop mapping.
OTN Receive - OTN OH
The OTN Receive Overhead screen contains the following read-only functions.
Function
OTU Overhead
211
Options
Displays the Optical Channel Transport Unit (OTU) overhead
bytes on the incoming signal. This is a read-only function.
Use the SAPI Expected and DAPI Expected buttons to
configure expected OTU SAPI and DAPI trace values.
A Trace Identifier Mismatch (TIM) alarm will be trigger if
the expected and received OTU SAPI and/or DAPI traces
don't match, and if the OTU SM TIM Alarm Reporting setting