VeEX MPA User Manual page 564

MPA_e_manual_D07-00-129P_RevA00
Max Frame Loss
Max Jitter
Frame Lengths, as shown in Table 1.
When editing the Frame Size for each Service #, use the
Prev/Next buttons at the bottom of the Traffic Stream Profile
window to change to the previous or next Service # (Stream
ID #), then select Save All to save all of the edited Services at
one time.
Service #
Service 01
Service 02
Service 03
Service 04
Service 05
Service 06
Service 07
Service 08
Service 09
Service 10
Table 1 – Recommended Frame Sizes/Lengths for each Service
Number
Allows the user to configure the selected Service's Maximum
Frame Loss Pass/Fail threshold rate, for both the
Configuration tests and the Performance test.
The Max Frame Loss rate can be set from 0.00% to
99.0%, per Service.
If the measured Frame Loss% exceeds this value while
testing the selected Service, then Configuration Test Results
Status will show "FAIL" for that Service.
Allows the user to configure the selected Service's Maximum
Packet Jitter Pass/Fail threshold, in µsec.
The Max Jitter can be set from 0 to 100000, per Service.
If the measured Jitter exceeds this value while testing the
selected Service, then Configuration Test Results Status will
show "FAIL" for that Service.
Frame Size (bytes)
64
128
256
512
1024
1280
1518
MTU
User Defined (Optional)
User Defined (Optional)
Packet Tab
564