VeEX MPA User Manual page 541

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Ramp Mode Settings
Select MPLS/VLAN
Tagging
MPLS Label
MPLS TC
541
packets within the burst, and longer than normal IPG's between
the bursts.
See How to use the Burst Mode for Ethernet Traffic
Generation for information on Burst mode testing.
The following settings become enabled when a Ramp rate is
selected:
•
Ramp Step: This is the size of the % Bandwidth or Mbps
rate that each step (up and down) should change by.
•
Ramp Floor: This is the minimum % Bandwidth or Mbps
rate that the stream will step down to.
•
Ramp Duration: This is the number of Seconds (1 to 999)
that each step (up and down) will transmit for.
See How to use the Ramp Mode for Ethernet Traffic
Generation for information on Ramp mode testing.
Enables either VLAN, MPLS, or No Tagging.
When testing VLAN or MPLS, up to 4 stacked tags can be
enabled by selecting the checkbox for the next tag. Each tag
adds 4 bytes to the Packet's header fields.
Configures the MPLS Label value. The default value is 0x1234,
but the menu lets you enter any 2-byte User Defined HEX value.
MPLS Tagging must be enabled to use this parameter
Configures the MPLS TC (Traffic Class) level. This is the frame's
priority level and is a 3-bit field ranging from the default value of 0
(best effort) to 7 (highest priority).