MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
LP Signal Label
Synchronization
Status (S1)
Trigger In
403
Bits 5 through 7 of the V5 byte are allocated for a LP Signal
Label to indicate the content of the LP SPE, including the
status of the LP mapped payload.
The following options are available:
•
00 (Unequipped)
•
01 (Equipped)
•
02 (Asynchronous)
•
03 (Bit Synchronous)
•
04 (Byte Synchronous)
•
(05) ATM
•
06 (O.181 Test Signal Mapping)
•
07 (VC-AIS)
•
User Defined - Any 3-bit value 0h to 7h
This option is only available for C-2, C-12, and C-11
mappings.
Allows the user to set the S1 byte to one of the following:
•
00 Quality Unknown)
•
02 (Rec. G.811)
•
04 (Rec. G.812 Transit)
•
08 (Rec. G.812 Local)
•
0B (Sync Eqip Timing Src (SETS))
•
0F (Do Not Use for Sync)
•
User Defined (any eight bit pattern 0 to FF)
Trigger In is currently not supported.