Restarting A Test; Presets Function - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
•
Select the Stop common function button located at the bottom of the touch
screen.
To restart test activity and statistic reporting, select the Restart button.

Restarting a Test

The Restart common function button is used to initiate the following test activities:
•
Clears and resets error, alarm, and event activity counters, statistics, and LEDs
for the current protocol processor.
•
Restarts monitoring for error, alarm, or event activity that was stopped using the
Stop button.
•
Elapsed Time counter resets to 000 Days, 00 Hours, 00 Minutes, and 00
Seconds, and then begins to increment after the Restart finishes.
To restart a test or reset statistics:
•
Select the Restart common function button located at the bottom of the touch
screen. Configured testing on the current protocol processor is restarted.

Presets Function

The Presets function provides a quick and convenient way to set up the system for
operation. Using Presets involves selecting a starting protocol and its interface, and
then making an internal connection to another protocol, such as Add/Dropping from
OTN to a lower SONET/SDH mapping.
To set up a connection using the Presets function:
1. Select Presets from the Common Function Buttons row.
2. Select Interface. All line interfaces available for your unit appear.
3. Select an interface as a starting point.
4. Select Configuration. The protocols available for the selected interface appear.
5. Select a protocol to connect to the interface. If required, select the
Configuration button again to create additional connections.
Common Function Buttons
54