VeEX MPA User Manual page 642

MPA_e_manual_D07-00-129P_RevA00
Initial Laser Setting
Information about the configuration of the streams are displayed in the Stream Profile
Table.
At the left, there is one button to turn on and off the fibre channel stream. The other
columns of information can be seen by using the scroll bar at the bottom or by
rearranging the columns. These are the columns (note that the sequence may be
different, depending upon how the user has arranged the columns):
TX
received since the test was started.
•
Mbit/sec - Displays the current rate of frames sent or
received in Megabits per second.
•
%BW - Displays the total percent of bandwidth used
by each active stream.
Controls whether the laser is on or off when the unit is turned
on.
The following options are available:
•
Off - The unit's laser will be off when the unit is turned
on.
•
On - The unit's laser will be on when the unit is turned
on.
•
Restore Previous State - When the unit is turned on,
the laser will be on or off based on its previous setting
before the unit was turned off.
Indicates whether the Fibre Channel stream is being
transmitted (On) or not (Off)
Packet Tab
642