MPA_e_manual_D07-00-129P_RevA00
•
Multi-Stream Configuration
•
Initiating Auto Negotiation
•
Ramp Mode Traffic Generation
•
Burst Mode Traffic Generation
•
Enabling Stacked VLAN Tagging
•
Enabling MPLS Label Stacking
•
Transmitting Packet Streams
•
Inserting a Pause (Flow Control) into a Stream
•
Inserting Errors and Alarms
•
Viewing Error and Alarm Results
•
Configuring an RFC-2544 Test
•
RFC-2544 - Throughput Testing
•
RFC-2544 - Frame Loss Testing
•
RFC-2544 - B2B Burst Testing
•
Y.1564 Performance Testing Overview
•
Y.1564 Service Configuration and Testing
•
Timed Test Using Acceptance Criteria
•
Measuring Service Disruption
•
Saving and Printing Statistics and Settings Reports
Configuring Packet Streams
(Specifically for LAN/WAN Ethernet testing)
The
Config > Strms Pg1 and Strms Pg2
or edit any or all of the available packet streams.
To configure a packet stream:
1. Select the desired Ethernet Interface rate from the OTN or SONET/SDH tab,
then select the Packet tab.
2. Select Config and choose SET.
3. If any of the port's configuration settings need to be changed, then configure the
settings as needed.
4. Choose a Strms Pg # side tab. (Where # is either 1 or 2 depending on which
stream(s) you want to set.)
screens provides the tools required to configure
Packet Tab
600