Table of Contents
Advertisement
MPA_e_manual_D07-00-129P_RevA00
Important: Multi-Stream Configuration is only available when the processor is
licensed for the Advanced Ethernet test option, enabling up to 32 independent test
streams per port. Otherwise, this feature is unavailable when only 1 test stream is
enabled.
Multi-Stream Configuration is not supported on the MPM-400G card, which currently
supports a single test stream.
This function will also configure each of the affected Streams with the same values
for all of the other stream settings such as; Frame Length, Payload, BW, Burst Size,
Ether Type, UDP addresses, VLAN/MPLS settings, Etc., when the "Save All" button
is selected.
Procedure:
1. When configured for any Ethernet rate, select Config, then Strms Pg 1 or Strms
Pg 2. From the
(1-16) or (17-32) in the white area. The
screen will appear. Multi-Stream Configuration will begin from the selected
Stream.
2. Select
3. When this button is selected, the user will be prompted to select the number of
additional Streams to edit (from the current Stream id up to #32), keeping in mind
that the Multi-Stream Configuration will begin from the selected Stream.
The increment feature can be applied from the selected Stream up to Stream
32. For example, if Stream 30 is selected, Streams 30, 31, & 32 can be
incremented.
After the number of additional Streams is entered, a new Profile window is
displayed.
4. This new Stream Profile window displays the affected Streams id's beside the
Multi Stream Config button and also displays the Increment (Incr) checkboxes
Stream Profile
Table, select any Stream by touching any Stream
located above the MAC Src.
traffic Stream profile
for the selected
Packet Tab
602
- Quick Links:
- Configuring the Ip Address
Hide quick links:
Advertisement
Table of Contents
