VeEX MPA User Manual page 745

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Settings
Statistics
Events
Serv Disrupt
RFC Thru Put
RFC Frame Loss
RFC B2B Burst
RFC Combined
To save or print test results:
1. Configure and run Packet Stream transmissions or perform an RFC-2544 test.
2. Select the Report common function button located at the bottom of the screen.
The Report Setup dialog box appears.
3. Select the Destination Printer or File type. The following report Destinations are
available:
745
Reports the Stream Settings for the selected Port.
Reports all Steam Tx/Rx Packet counts, Errors, and Alarms.
Reports a summary of Events, such as alarm and error activity.
Reports Service Disruption statistics.
Reports the Throughput test settings and a summary of the test
results for each packet size (passing rate, transmitted and
received packets, minimum/maximum/average latency).
Reports the Frame Loss test settings and a summary of the test
results for each packet size (passing rate, transmitted and
received packets, minimum/maximum/average latency).
Reports the Back to Back Burst test settings and a summary of
the test results for each packet size (Max Possible Number of
Frames, and Average Observed B2B Frames).
Combines the RFC Thru Put, RFC Frame Loss and RFC B2B
Burst reports into one report.