VeEX MPA User Manual page 697

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Stream ID #
Multi Stream Config
MAC Src address
MAC Dest address
697
Displays the Stream ID # that the settings are being modified for.
The title bar of this Traffic Stream Profile window also shows
which Stream ID # is currently selected.
Automatically increments the Source and Destination IP and
MAC address values on up to all 32 Streams, and applies other
global changes to each selected Stream, all in one step. See
Ethernet Multi-Stream Configuration
Important: Multi-Stream Configuration is only available when
the processor is licensed for the Advanced Ethernet test option,
enabling up to 32 independent test streams per port. Otherwise,
this feature is unavailable when only 1 test stream is enabled.
Sets a Source MAC (origination) address for generated traffic.
The address is a 12-digit (6-octets) HEX value that is entered
using a keypad. The address is entered into 6 separate fields, 2
characters each. There are no restrictions on value entered but
all a value must be entered in all fields.
Sets a Destination MAC address for generated traffic. The
address is a 12-digit (6-octets) HEX value that is entered using a
keypad. The address is entered into 6 separate fields, 2
characters each. There are no restrictions on values entered,
except that all a value must be entered into all fields.
For "Unicast Packets" the 1st octet for the Destination MAC
addresses should be set to an even number such as "00".
For "Multicast Packets" the 1st octet for the Destination MAC
addresses should be set to an odd number such as "01".
For "Broadcast Packets" all 6 octets of the Destination MAC
addresses should be set to "FF".
for details.