VeEX MPA User Manual page 688

MPA_e_manual_D07-00-129P_RevA00
Reflect
VLAN RX
TPID
Count
Statistics
Table
Config - Set screen
(Specifically for GFP-Bulk Fill testing on the Packet tab)
Allows the user to start IP Packet Reflection Mode for DLI Packets
or All Non-Routing Packets.
Important: This setting is only supported in GFP-Transparent
Filters the Stream Results RX packet count by the Streams VLAN
TPID values.
Each DLI test Stream can contain up to (4) stacked VLAN tags,
(1) S-VLAN (service provider) tag and up to (3) C-VLAN
(customer) tags, each with a unique TPID (Tag Protocol Identifier)
value. The VLAN RX TPID section allows the processor to only
count those packets whose VLAN TPID are specified by the TPID
filter options.
Four filters are available, "A" through "D". Filter "A" is mandatory
and always enabled, "B" through "D" are optional.
Each filter has a menu that allows the user to select a
predefined TPID value (0x8100, 0x88A8, 0x9100 and 0x9200), or
enter a user defined value.
The Count Statistics Table displays the following information for
both transmitted (TX) and received (RX) packets:
•
TX/RX - Defines which row of statistics is designated for
Transmit counts (TX) and which row is designated for
Receive counts (RX)
•
Packets - Displays the total number of packets sent and
received since the test was started
•
Pkts/sec - Displays the current rate of packets sent and
received in packets per second
•
Bytes - Displays the total number of bytes sent and
received since the test was started
•
Mbit/sec - Displays the current rate of packets sent and
received in Megabits per second
•
%BW - Displays the current percentage of bandwidth of
packets sent and received
Packet Tab
688