VeEX MPA User Manual page 517

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
2. Choose the Report type(s) to be printed or saved.
The most common report is the Statistics report, which contains a complete list of
error and alarm statistic information as well as other counts that pertain to the test
performed.
Multiple reports can be combined into one file by selecting more than one report type.
The reports listed below are only available for the SDH protocol processor.
Settings
Statistics
Events
APS
Performance Reports the Performance Monitoring results.
Capture
Serv Disrupt
RTD
Module Info
3. Select the Destination Printer or File type. The following report Destinations are
available:
Printer
Text File
Delimited
517
Reports the Stream Settings for the selected Port.
Reports all Steam Tx/Rx Packet counts, Errors, and Alarms.
Reports a summary of Events, such as alarm and error activity.
Reports the K1/K2 byte sequences results summary.
Reports the results from an overhead byte capture test
Reports Service Disruption statistics.
Reports the Round Trip Delay measurements.
Reports the SFP Module Information.
Only supported on the MPM-10G card, see the MLD tab for other
card types.
** Module Not Present ** is shown when laser module is not
inserted.
The selected report is sent to your PC's default printer.
The selected report is saved as an ASCII text file, with a .txt file
extension.
The selected Settings or Statistics report is save as a text file, using