VeEX MPA User Manual page 715

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
BW Floor
Packet Size
buttons
Statistics Table
First, Prev, Next,
Last
Start/Stop Test
The following list of tasks demonstrate how to configure and test each of the RFC-
2544 benchmark tests.
•
To Configure the RFC-2544 test settings see
•
To run an RFC-2544 Thru Put test see
•
To run an RFC-2544 Frame Loss test see
•
To run an RFC-2544 B2B Burst test see
715
Displays the setting for the low-end of the bandwidth test
range.
The BW Floor is configured from the RFC Tests - Conf
screen.
Determines which packet size results appear in the statistics
table. Selecting a packet size button displays its results.
Displays the frame loss test results for a specified packet
size. The results display the nine rates determined by the BW
Ceiling and BW Floor settings. The following statistics are
displayed:
Rate % - Indicates the percentage of bandwidth transmitted
using the bandwidth ceiling and floor settings.
Transmit Frames - Reports the total number of frames
transmitted.
Receive Frames - Reports the total number of frames
received.
Loss % - Reports the percentage of frame loss that occurred
during the test. This calculation is the received frames divided
by transmitted frames.
Allows the user to scroll through packet sizes to view their
test results.
Starts and stops the Frame Loss test. The button toggles
between Start (when a test is not running) and Stop (when a
test is running).
What are RFC 2544 Tests?
Throughput Testing
Frame Loss Testing
Back-to-Back Burst Testing