VeEX MPA User Manual page 603

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
beside the applicable address buttons. These checkboxes are initially unchecked
when the window is opened. Select the appropriate checkboxes and enter the
initial Address required for each of the selected addresses.
If an address Incr checkbox is not selected then the specified address will be
applied to all of the affected Streams
5. For each address with its Incr checkbox selected, the last part of the address
(circled in red above) will be incremented by 1 for each subsequent Stream when
the "Save All" button is selected.
The MAC addresses and IPv6 IP addresses will increment by hex values
6. The example shown in the Stream Profile window above will result in the
following values for each Stream (in this case Streams 1-32).
7. The Multi-Stream Configuration feature can also be used to will also configure
each of the affected Streams with the same values for all of the other stream
settings such as; Frame Length, Payload, BW, Burst Size, Ether Type, UDP
addresses, VLAN/MPLS settings, Etc., when the "Save All" button is selected.
Initiating Auto Negotiation
(Specifically for LAN/WAN Ethernet testing on the Packet tab)
603