Lock Icon Overview - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
Getting Started
Thus, the GUI labels the tab names for to the first two test ports in slot 1 as "S1-P1" and
"S1-P2", and the next two test ports in slot 2 as "S2-P1" and "S2-P2", and so on.
In these examples, an MPM-100G is located in the Slot 5. Because the MPM-100G
card only contains one test port, the GUI refers to the MPM-100G's test port in Slot 5 as
"S5-P1".
Similar to the MPM-10G card, the MPM-100AR card also has two test ports, referred to
as S6-P1 and S6-P2, in the 3rd generation MPA chassis example above.
The MPM card types in each slot may vary from one MPA unit to another, but the
dedicated Slot numbers for each of the three generation chassis designs will always be
the same, regardless of what card type in each slot.
Test Units
For the purpose of this document, a "Test Unit" consists of all of the
Processors that share the same Slot/Port, and
tabs for "Test Unit #1" in the GUI correspond to "S1-P1", and the second set of Protocol
Processor tabs for "Test Unit #2" correspond to "S1-P2", etc.
Both Port 1 and Port 2 on an MPM-10G card can be independently licensed, and each
can support Protocol Processor tabs for OTN, SONET/SDH, and PACKET (for
Ethernet, GFP and Fibre Channel testing).
The following MPM test modules are currently supported by the MPA system:
•
MPM-10G Module Overview
•
MPM-100G Module Overview
•
MPM-100AR Module Overview
•
MPM-400G Module Overview

Lock Icon Overview

The unit's multi-user functionality allows up to twenty (20) simultaneous users to be
connected to a portable unit. This includes
desktop connection, or
77
remote GUI
SCPI command sessions.
Lock icon. Thus, the Protocol Processor
connections,
Protocol
VNC remote