VeEX MPA User Manual page 653

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
This is an RFC 2544 benchmark test. Its purpose is to determine the number of frames
lost by looping a stream (with a specified frame size) through the network at varying
transmit frame rates. Select
The following options appear on the Frame Loss screen:
Option
Stream ID
Trial Duration
BW Ceiling
WWN Dest
Address
Dest Port
BW Floor
Packet Size
buttons
653
Frame Loss Testing
Description
Displays the ID number of the stream that will be used for the
RFC test.
The Stream ID is configured from the RFC Tests - Conf
screen.
Displays how long the test will run for each packet size. This
duration is used each time the test fails.
The Trial Duration
screen.
Displays the setting for the high-end of the bandwidth test
range.
The BW Ceiling is configured from the RFC Tests - Conf
screen.
Displays the destination WWN address of the device that will
receive the RFC test.
The WWN Dest Address
Stream ID from the Traffic Stream Profile on the Conf screen.
Displays the destination port that will receive the test signal.
The destination port configuration setting is not supported
on the MPA.
Displays the setting for the low-end of the bandwidth test
range.
The BW Floor is configured from the RFC Tests - Conf
screen.
Determines which packet size results appear in the statistics
table. Selecting a packet size button displays its results.
for test procedures.
is configured from the RFC Tests - Conf
is configured for the selected