VeEX MPA User Manual page 530

MPA_e_manual_D07-00-129P_RevA00
Count Statistics
Table
Initial Laser Setting
Config - Strms Pg 1 and Strms Pg 2
(Specifically for LAN/WAN Ethernet testing on the Packet tab)
The Strms Pg 1 (Streams Page 1) and Strms Pg 2 (Streams Page 2) screens are used
for configuring and testing packet streams.
0x9200), or enter a user defined value.
The Count Statistics Table displays the following information
for both transmitted (TX) and received (RX) packets:
•
TX/RX - Defines which row of statistics is designated
for Transmit counts (TX) and which row is designated
for Receive counts (RX)
•
Packets - Displays the total number of packets sent
and received since the test was started
•
Pkts/sec - Displays the current rate of packets sent
and received in packets per second
•
Bytes - Displays the total number of bytes sent and
received since the test was started
•
Mbit/sec - Displays the current rate of packets sent
and received in Megabits per second
•
%BW - Displays the current percentage of bandwidth
of packets sent and received
Controls whether the laser is on or off when the unit is turned
on.
The following options are available:
•
Off - The laser will be off when the unit is turned on.
•
On - The laser will be on when the unit is turned on.
•
Restore Previous State - When the unit is turned on,
the laser will be on or off based on its previous setting
before the unit was turned off.
Packet Tab
530