VeEX MPA User Manual page 662

MPA_e_manual_D07-00-129P_RevA00
Results - Strm Rslt (Stream Results) Screen
(Specifically for Fibre Channel SAN testing on the Packet tab)
The Stream Results screen displays the following statistics for the incoming stream:
Statistic
Selected Stream
Entry
Total Stream
Statistics Table
Pass/Fail Test
primitives need to be transmitted based on how many frames
were received. Credit is returned for frames that have a valid
SOF and at least one word of data following the SOF,
independent of the validity of the CRC.
Description
Displays the stream's WWN source and WWN destination
addresses.
Provides transmit and receive statistics by Count and %BW.
Transmit Statistics:
•
Packets - Total number of Packets transmitted.
•
Bytes - Total number of Bytes transmitted.
•
BW - Percent of bandwidth currently being
transmitted.
Receive Statistics:
•
Packets - Total number of Packets received.
•
Bytes - Total number of Bytes received.
•
BW - Percent of bandwidth currently being received.
•
Loss - Current Packet Loss rate.
For loop backs with large latency, the Loss rate may
show greater than 0 while the test stream generation is
active, even if no packets are actually being lost
(dropped). This is due to the real-time RX packet count
being lower than the TX packet count, because of the
latency. If no packets were lost during the test, then
this value will drop to 0 when the test stream
generation is turned off.
Provides User-Defined Acceptance Criteria:
Refer to Timed Test Using Acceptance Criteria
Packet Tab
662