Displaying All Test Status - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
GUI System Tab

Displaying All Test Status

The MPA can operate multiple tests simultaneously. Each Protocol Processor has a
panel of Error, Alarm and Status LED Indicators to display the status and history of the
current test. The All Test Status screen allows the user to observe, at a glance, the
status of all simultaneous tests.
To view All Test Status, select the
under the System Tab.
When in this All Test Status mode, each circuit pack is polled. You may notice a
slight delay in status reporting based on your unit's configuration.
The All Test Status screen is a general summary screen for up a maximum of 12
protocol processor tabs at one time. If the unit contains more than 12 circuit packs
(protocol processor tabs), the protocol processor tabs appear in groups of 12. Select the
All Test button (All Test (1 to 12)) to scroll through the various groups.
The following information appears for each protocol processor or individual port number:
1. Protocol Processor tab name
2. Elapsed time (in minutes)
3. Summary LED (See
•
A Red Summary LED indicates that at least one "Conditional" LED is currently
Red in the LED Status Indicator section of the Protocol Processor
•
A Green Summary LED indicates that at least one "Conditional" LED is currently
Green, and none of the "conditional" LEDs are currently Red, in the LED Status
Indicator section of the Protocol Processor
•
A White Summary LED indicates either none of the "Conditional" LEDs are
currently Green or Red in the LED Status Indicator section, or status LEDs are
selected (checked) to be "Conditional"
•
A Gray Summary LED indicates that the Protocol Processor tab is currently
disabled
787
button from any protocol processor or select
Conditional LED options below)