VeEX MPA User Manual page 526

MPA_e_manual_D07-00-129P_RevA00
Line Control
Status
Reflect
Configures the electrical interface Line Control mode.
Auto - Set line control mode to Auto-negotiate
Master - Set line control mode to Master only
Slave - Set line control mode to Slave only
The Line Control setting is only available for 1 Gbps elect
@ FDX interface.
Electrical Ethernet rates require an Electrical RJ-45 SFP
module.
Displays the current Negotiate or Line Control status.
This setting is only available for applicable Ethernet
Interface rates.
Allows the user to start IP Packet Reflection Mode.
Valid options are:
Digital
Lightwave
Packets Only
All Non-Routing
Packets
Thru Mode
This will only reflect back data packets
that were generated from a Digital
Lightwave test unit.
When these packets are reflected,
the Source and Destination MAC
addresses and IP Addresses are
swapped, to allow the packets to be
re-routed back to the originating
source.
This will reflect back all data packets,
not just from Digital Lightwave test
units, but it will not reflect Routing
packets such as ARP and negotiation.
This will pass through every data
Packet Tab
526