VeEX MPA User Manual page 714

MPA_e_manual_D07-00-129P_RevA00
•
To run an RFC-2544 B2B Burst test see
RFC Tests - Frame Loss Test
This is an RFC 2544 benchmark test. Its purpose is to determine the number of frames
lost by looping a stream (with a specified frame size) through the network at varying
transmit frame rates. Select
The following options appear on the Frame Loss screen:
Option
Stream ID
Trial Duration
BW Ceiling
Dest MAC
Address
Dest Port
Frame Loss Testing
Description
Displays the ID number of the stream that will be used for the
RFC test.
The Stream ID is configured from the RFC Tests - Conf
screen.
Displays how long the test will run for each packet size. This
duration is used each time the test fails.
The Trial Duration
screen.
Displays the setting for the high-end of the bandwidth test
range.
The BW Ceiling is configured from the RFC Tests - Conf
screen.
Displays the destination MAC address of the device that will
receive the RFC test.
The Dest MAC Address
Stream ID from the Traffic Stream Profile on the Conf screen.
Displays the destination port that will receive the test signal.
The destination port configuration setting is not supported
on the MPA.
Back-to-Back Burst Testing
for test procedures.
is configured from the RFC Tests - Conf
is configured for the selected
Packet Tab
714