How To Install The Chassis Into A Rack; Mpa Power Connections - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
MPA Chassis
Static electricity can harm electronic components. You must wear proper ESD
protection, such as ESD shoe grounders or an ESD wrist strap, before installed or
exchanging any electric component within this system.

How to install the chassis into a rack

1. Determine where you want to install the 1U chassis in the telecommunication
rack/cabinet.
The chassis requires ventilation on the left and right sides of the chassis only
No ventilation is required on the top or the bottom of the chassis.
2. Lift and position the chassis into place. Align the four screw slots on the mounting
brackets with the screw holes on the rack's rails.
3. While one installer holds the chassis in place, insert the first customer-supplied
rail screw into one of the bottom screw slots on the mounting bracket and fasten
the screw to the mounting rail.
4. Insert another rail screw into the opposite bottom mounting bracket and fasten
the screw to the mounting rail. This provides temporary support of the unit in the
rack.
5. Attach the remaining two customer-supplied rail screws to the mounting brackets'
top screw slots.
6. For ESD protection and to avoid electrical shock, see
on how to ground the instrument, depending on the type of power supply is in
your MPA chassis.

MPA Power Connections

The 2nd Generation MPA chassis includes a pluggable Power Module slot that allows
users to switch between AC and DC power supplies.
87
MPA Power Connections