VeEX MPA User Manual page 56

MPA_e_manual_D07-00-129P_RevA00
2. Choose the Report type(s) to be printed or saved.
The most common report is the Statistics report, which contains a complete list of
error and alarm statistic information as well as other counts that pertain to the test
performed.
Multiple reports can be combined into one file by selecting more than one report type.
Some of the reports listed below are only available for specific protocol processors.
Settings
Statistics
Events
APS
Performance Reports the Performance Monitoring results.
Capture
Serv Disrupt
RTD
RFC Thru
Put
RFC Frame
Loss
RFC B2B
Burst
RFC
Combined
Y1564
Settings
Y1564 Ramp
Reports the Stream Settings for the selected Port.
Reports all Steam Tx/Rx Packet counts, Errors, and Alarms.
Reports a summary of Events, such as alarm and error activity.
Reports the K1/K2 byte sequences results summary.
Reports the results from an overhead byte capture test
Reports Service Disruption statistics.
Reports the Round Trip Delay measurements.
Reports the Throughput test settings and a summary of the test
results for each packet size (passing rate, transmitted and received
packets, minimum/maximum/average latency).
Reports the Frame Loss test settings and a summary of the test
results for each packet size (passing rate, transmitted and received
packets, minimum/maximum/average latency).
Reports the Back to Back Burst test settings and a summary of the
test results for each packet size (Max Possible Number of Frames,
and Average Observed B2B Frames).
Combines the RFC Thru Put, RFC Frame Loss and RFC B2B Burst
reports into one report.
Reports the Y.1564 Settings including the Ramp Steps and enabled
Service Stream settings.
Reports the Y.1564 Configuration Ramp test summary for each
Service Stream tested (Step, CIR%, Frame Loss%, Max Jitter, Max
Common Function Buttons
56