VeEX MPA User Manual page 565

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Max Latency
CIR
CIR+EIR
Y.1564 - Results
The Y.1564 Results screen shows the summary overview of the Configuration and
Performance test results for all services are displayed.
565
Allows the user to configure the selected Service's Maximum
Delay Latency Pass/Fail threshold, in µsec.
The Max Latency can be set from 0 to 100000, per
Service.
If the measured Latency exceeds this value while testing
the selected Service, then Configuration Test Results Status
will show "FAIL" for that Service.
Allows the user to set the maximum % Committed Information
Rate (bandwidth), that the network is committed to transfer
while meeting the performance level guaranteed in the
service level agreement (SLA).
The CIR bandwidth rate can be set from 0.01% to 100%,
per Service.
Allows the user to set the additional Excess Information Rate
(bandwidth), by which a user can exceed its CIR with some
expectation that the excess traffic might be carried though the
network.
The CIR+EIR can never be a value less than the CIR.
Setting the CIR+EIR to the same value as the CIR,
essentially sets the EIR to 0%.