MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
The following Specific Tasks for this protocol processor are discussed:
•
Configuring GFP Packet Streams
•
Inserting GFP Errors and Alarms
•
Viewing GFP Error and Alarm Results
•
Using the Event Log
•
Saving and Printing Statistics and Port Settings
•
GFP mapping for OTU-1 and OTU-2 OTN interfaces
•
Configuring an RFC-2544 Test
•
RFC-2544 - Throughput Testing
•
RFC-2544 - Frame Loss Testing
•
RFC-2544 - B2B Burst Testing
Configuring GFP Packet Streams
(Specifically for GFP Mappings and GFP-F or GFP-T modes)
The
Config > Set (Stream Control)
edit GFP packets.
To configure a packet stream:
1. Configure the GFP Payload setting from the SONET/SDH tab, or the GFP
Mapping from the OTN tab; depending on the configured Interface.
2. Select the Packet tab, then select Config and choose Set.
3. Select either GFP Framed Ethernet or GFP Transparent mode.
4. Make any needed changes to the PFI, EXI, PTI or UPI overhead settings, as
needed.
5. Choose a
Strms Pg #
stream(s) you want to set.)
6. Select a desired stream to test in the Stream Profile table. The Traffic Stream
Profile dialog box appears.
7. From the
Traffic Stream Profile
stream.
739
screen provides the tools required to configure or
side tab. (Where # is either 1 or 2 depending on which
dialog box, set the parameters for the packet