MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
LP-TC-UNEQ
LP-TC-LOF
Test
SDH Test Screens and Functions
The Test screen configures test parameters associated with a SDH protocol processor.
The Test screen contains the following functions:
•
SET 1
•
Service Disruption
•
RTD
•
SFP Info
(MPM-10G only)
SDH Test - Set 1
The SET 1 functions determine how long a protocol processor's test runs and what
activities occur at the end of the test.
The following appears on the SET 1 screen.
Function
Duration
489
Tandem Connection-Unequipped. Indicates that a 00h
pattern has been detected in the N2 byte of a Tandem
Connection. This is an alarm LED.
Tandem Connection-Loss of Frame. Indicates the loss of a
valid multiframe frame alignment signal (FAS) pattern from
upstream TCM equipment. This is an alarm LED.
Description
This function configures how long a timed test runs. The
following options are available:
•
Continuous - Test is untimed, and unit is always
collecting data.
•
5 Minutes - Test runs for 5 minutes.
•
15 Minutes - Test runs for 15 minutes.