VeEX MPA User Manual page 640

MPA_e_manual_D07-00-129P_RevA00
Fabric Login
•
10 Gbps Fibre Channel
•
8 Gbps Fibre Channel
•
4 Gbps Fibre Channel
•
2 Gbps Fibre Channel
•
1 Gbps Fibre Channel
The MPM-10G card also supports 10 Gbps Fibre
Channel in OTN by selecting OTU1f (11.270G) or OTU2f
(11.317G) from the OTN tab's Interface menu.
Available interface rates and mappings are dependent on
the licensed-based test options currently enabled.
All currently licensed interface rates are displayed in the
Interface menu, regardless if the rates are actually supported
by the currently inserted laser modules or not. Verify that the
inserted laser module supports the desired Interface rate
prior to selecting it.
The Packet processor supports hot-swappable laser
modules.
The wavelength of the selected interface is determined by
the specifications of the pluggable laser module being used.
Constant LOS or Link State alarms may be present when
an unsupported Interface rate or mapping selected or if the
required laser module is unplugged.
Not Assigned is displayed if one of the Interfaces listed
above is currently not selected.
When SONET, SDH or OTN are configured for GFP
payload mapping, then the Mode menu will also contain
Framed, GFP Transparent
For Ethernet testing see the
Attempts a Fabric Login
This is disabled when the test stream is On.
and GFP Bulk options.
LAN/WAN Ethernet
Packet Tab
GFP
section.
640