VeEX MPA User Manual page 668

MPA_e_manual_D07-00-129P_RevA00
(Specifically for Fibre Channel SAN testing on the Packet tab)
The SET 1 functions determine how long a protocol processor's test runs and what
activities occur at the end of the test.
The following appears on the SET 1 screen.
Function
Duration
Action After
Duration
Description
This function configures how long a timed test runs. The
following options are available:
•
Continuous - Test is untimed, and unit is always
collecting data.
•
5 Minutes - Test runs for 5 minutes.
•
15 Minutes - Test runs for 15 minutes.
•
1 Hour - Test runs for 1 hour.
•
2 Hours - Test runs for 2 hours.
•
24 Hours - Test runs for 24 hours.
•
72 Hours - Test runs for 72 hours.
•
1 Week - Test runs for 1 week.
•
2 Weeks - Test runs for 2 weeks.
•
User Defined - Allows a specific test duration to be
entered using a touch screen keypad. The minimum
duration is 1 minute. The maximum duration is 99
days, 23 hours, and 59 minutes.
After configuring the Duration, you must select Restart in
order for the Timed Test to begin.
Action after Duration defines what activities occur at the
conclusion of a timed test. It allows several different options,
including printing results to a printer or recording them to a
file; repeating a test or just processing one test. Test results
appear in a columned report format; however, there is one
option available to record the statistics using a delimiter.
The table below describes the Action after Duration options.
Action after Duration
Options
Packet Tab
Description
668