VeEX MPA User Manual page 471

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
•
ES - Errored Seconds. Reports the duration of the incoming MS-REI errored
blocks per seconds, the percentage of errored seconds compared to the duration
of error free seconds, and the objective percentage.
•
EFS - Error Free Seconds. Reports the duration of the incoming MS-REI error
free seconds and the percentage of error free seconds compared to the duration
of errored seconds.
•
SES - Severely Errored Seconds. Reports the duration of Severely Errored
Seconds (SES), rate percentage, and objective percentage on the incoming SDH
signal. An SES is reported when the number of MS-REI errored blocks per
second equals or exceeds either the G.826 or G.829 MS SES Threshold (see
table below), or when an MS-RDI alarm is present.
•
G.826 Allocation. Select an allocation percentage from 0 to 100.
•
G.826 Status. Pass, Uncertain, or failure
•
G.826/G.829 - Select the command button to toggle between G.826 and G.829
error statistics.
G.829 does not support allocation, objective percentages or status
M.2101.1 Near B2 Errors
•
ES - Errored Seconds. Reports the duration of the incoming B2 errored blocks
per seconds, the percentage of errored seconds compared to the duration of
error free seconds, and the S1 and S2 percentage.
•
SES - Severely Errored Seconds. Reports the duration of Severely Errored
Seconds (SES), rate percentage, and the S1 and S2 percentage on the
incoming SDH signal. An SES is reported when the number of B2 errored blocks
per second equals or exceeds 2,400 errors per second, or when an Out Of
Frame (OOF) alarm, Loss of Frame
•
M.2101.1 Allocation. Select an allocation percentage from 0 to 100.
•
Duration. Set to 2 Hours, 1 Day, or 7 Days.
•
Status. Pass, Uncertain, or failure
M.2101.1 Far MS-REI Errors
•
ES - Errored Seconds. Reports the duration of the incoming MS-REI errored
blocks per seconds, the percentage of errored seconds compared to the duration
of error free seconds, and the S1 and S2 percentage.
•
SES - Severely Errored Seconds. Reports the duration of Severely Errored
Seconds (SES), rate percentage, and the S1 and S2 percentage on the
incoming SDH signal. An SES is reported when the number of MS-REI errored
471