VeEX MPA User Manual page 634

MPA_e_manual_D07-00-129P_RevA00
To Stop monitoring Service Disruption measurement activity:
1. Select the Test tab and choose Service Disrptn from the tabs along the left-side
of the screen.
2. From the Action box, select State and choose Stop APS.
Saving and Printing Statistics and Settings Reports
(Specifically for LAN/WAN Ethernet testing)
The Packet tab provides the option to Print or Save the following test reports to a file for
access later or for immediate printing; Stream Settings, Stream Test Statistics, the
Events Log, Service Disruption measurements, RFC Throughput, RFC Frame Loss,
RFC B2B Burst, RFC Combined, Y.1564 Settings, Y.1564 Ramp, Y.1564 Performance,
and Y.1564 Combined reports.
Multiple reports can be combined into one file by selecting more than one report type.
The following reports are available from the Packet tab:
Settings
Statistics
Events
Serv Disrupt
RFC Thru Put
RFC Frame Loss
RFC B2B Burst
RFC Combined
Reports the Stream Settings for the selected Port.
Reports all Steam Tx/Rx Packet counts, Errors, and Alarms.
Reports a summary of Events, such as alarm and error activity.
Reports Service Disruption statistics.
Reports the Throughput test settings and a summary of the test
results for each packet size (passing rate, transmitted and
received packets, minimum/maximum/average latency).
Reports the Frame Loss test settings and a summary of the test
results for each packet size (passing rate, transmitted and
received packets, minimum/maximum/average latency).
Reports the Back to Back Burst test settings and a summary of
the test results for each packet size (Max Possible Number of
Frames, and Average Observed B2B Frames).
Combines the RFC Thru Put, RFC Frame Loss and RFC B2B
Burst reports into one report.
Packet Tab
634