VeEX MPA User Manual page 529

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
EMIX Mode
VLAN RX TPID
529
Enables or Disables EMIX packet generation.
Valid options are: ID337 or Off
EMIX (Ethernet Mixture) packet generation is based on
Broadband Forum's G.fast certification test plan ID-337, and
is used to emulate up to 16 simultaneous DPU/CPE traffic
flows of varying frame sizes.
•
Supported for 10GE LAN/WAN, 2500BASE-X, 1GigE,
100Mbps, 10/100/1000BASE-T Ethernet interfaces
•
Each traffic flow (test stream) packet is generated per
the following frame sizes and probability table, and can
be configured with or without VLAN/MPLS tags.
•
All Ethernet frame sizes begin on the first byte of the
Destination MAC Address and end on the last byte of
the Frame Check Sequence (FCS)
Frame Size (bytes) Probability
64
256
1024
1500
1566
Filters the Stream Results RX packet count by the Streams
VLAN TPID values.
Each DLI test Stream can contain up to (4) stacked VLAN
tags, (1) S-VLAN (service provider) tag and up to (3) C-VLAN
(customer) tags, each with a unique TPID (Tag Protocol
Identifier) value. The VLAN RX TPID section allows the
processor to only count those packets whose VLAN TPID are
specified by the TPID filter options.
Four filters are available, "A" through "D". Filter "A" is
mandatory and always enabled, "B" through "D" are optional.
Each filter has a menu that allows the user to select a
predefined TPID value (0x8100, 0x88A8, 0x9100 and
0.175
0.014
0.088
0.673
0.050