VeEX MPA User Manual page 706

MPA_e_manual_D07-00-129P_RevA00
Error Rate Selects the error rate to be transmitted for the selected error type. Once
the error rate is selected, the system begins transmitting errors.
Select one of the following:
Alarm Selects an alarm to be transmitted. Once selected the system begins
Generated sending the alarm condition.
Select one of the following:
Config - RX OH screen
(Specifically for GFP Mappings)
The Config > RX OH (Overhead) screen displays the received overhead bytes for the
Selected CID.
Function
Selected CID
PLI
PTI
PFI
•
1E-<x> - X is an exponential value from 2 to 10. Selecting one of
these sets the error rate to 1 x 10
the higher the error rate.)
User Defined – Enter the desired error rate in increments of 0.1.
•
For example, with user defined, error rates are not limited to 1 x
-x
10 but more exact choices are available such as 2.6 x 10
-3
7.1 x 10
•
None - Turns alarm generation off.
•
LFD - Generates a constant Loss of Frame Delineation alarm
•
LOCCS - Generates a constant Loss of Client Character
Synchronization alarm. (sets the PTI to 100 and the UPI to 0000
0010)
•
LOCS - Generates a constant Loss of Client Signal alarm. (sets
the PTI to 100 and UPI to 0000 0001)
Description
Sets the received Channel ID value, ranging from 0 to 255. The
default value is 0.
Displays the received PDU Length Indicator value.
Displays the received Payload Type Identifier value.
Displays the received Payload FCS Identifier value.
Packet Tab
-x
(The smaller the exponential
-4
or
706