MPA_e_manual_D07-00-129P_RevA00
Chassis Mounting Brackets
The MPA unit is designed so it can be rack-mounted to a 19-in (48cm)
telecommunication equipment rack, using the mounting brackets
attached to either side of the chassis.
Because of the variety of screw thread dimensions used with different
racks, you must supply four (4) mounting screws specifically threaded
to attach the chassis to your rack's mounting rails.
An ESD Wrist Strap Terminal (4 mm banana jack) is located on the left
mounting bracket.
2nd Generation MPA Chassis Dimensions
3rd Generation MPA Chassis Dimensions
Danger of electrostatic discharge!
MPA Rackmount Installation
86