VeEX MPA User Manual page 543

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
Prev
Next
Save All
Exit
Config - Errors and Alarms
(Specifically for LAN/WAN Ethernet testing on the Packet tab)
The Error and Alarm screen allows the user to configure errors and alarms for insertion
into a stream to simulate various defects and anomalies. Simulating defects can
determine if the receiving equipment can detect and report an error in the incoming
signal.
Note that error insertion is disabled when in IP Reflection Mode.
Option
543
Moves to the stream with the next lower number.
If currently looking at stream #1, selecting "Prev" will bring up
stream #32. Note that changes made will not be saved until
"Save All" is selected.
Moves to the stream with the next higher number.
If currently looking at stream #32, selecting "Next" will bring up
stream #1. Note that changes made will not be saved until "Save
All" is selected.
Saves all changes made and closes the Traffic Stream Profile
window.
Closes the Traffic Stream Profile window without saving changes.
Description