MPA_e_manual_D07-00-129P_RevA00
TX PTI
TX UPI
TX CID
RX Pattern
Allows the user to configure the Payload Type Identifier value. The
TX PTI can be set to:
•
000 - Client Data Frame
•
100 - Client Mgmt Frame
•
User Defined (range from 1 to 7, entered using a touch
screen keypad)
See
inserting LOCS and LOCCS alarms
PTI.
Allows the user to configure the User Payload Identifier value.
The TX UPI can be set to:
•
0x01 - Framed Eth
•
0x02 - Framed PPP
•
0x03 - Trans FC
•
0x04 - Trans FICON
•
0x05 - Trans ESCON
•
0x06 - Trans GbE
•
0x08 - MAPOS
•
0xFD - GFP 64/66B LAN
•
0xFE - GFP bulk fill
•
User Defined (range from 1 bit to 32 bits and is entered
using a touch screen keypad)
See
inserting LOCS and LOCCS alarms
UPI.
Sets the transmitted Channel ID value, ranging from 0 to 255, in
the Extension Header. The default value is 0.
Important: The EXI mode has to be set for Linear for this setting
to be enabled.
Selects the type of pattern that the unit expects to receive on the
incoming GFP frames. The payload can be set to:
•
PRBS 31
•
User Defined (range from 1 bit to 32 bits and is entered
using a touch screen keypad)
Packet Tab
for their affect on the
for their affect on the
690