VeEX MPA User Manual page 357

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
SONET Test - SFP Info
The SONET, SDH and OTN protocol tabs on the MPM-10G module includes the
following SFP Info screen under the Test section.
The SFP Info screen displays common information from the pluggable SFP or SFP+
module's 2-wire (I2C) interface, as programmed by the module's manufacturer.
The SFP Info screen can also be used to write to the SFP's serial addresses as per the
SFF-8636 Specification.
The following 2-wire (I2C) Serial Addresses are compliant with SFF-8636
(Specification for Management Interface for Cabled Environments, Rev 2.7 January 26,
2016), Table 6-15 Upper Page 00h Memory Map.
I2C Function
Module ID
Connector Type:
Encoding:
Nominal Rate:
Rate Identifier:
357
Description
Displays the module's form-factor
Identifier code.
Example: SFP/SFP+
Displays the module's Connector Type.
Example: LC, MPO 1x12
Displays the module's Signal
Encoding.
Nominal bit rate per channel, units of
250 Mbps.
Displays the tags for extended rate
select compliance
Address Location
Page 00h Byte: 128
Size: 1 Byte
Ref. SFF-8024 Table 4-1
Page 00h Byte: 130
Size: 1 Byte
Ref. SFF-8024 Table 4-3
Page 00h Byte: 139
Size: 1 Byte
Ref. SFF-8024 Table 4-2
Page 00h Byte: 222
Size: 1 Byte
Complements Byte 140
See Table 32A.
Page 00h Byte: 141
Size: 1 Byte