Table of Contents
Advertisement
MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
IP Dest address
IP Mode
Ether Type
UDP Src port
UDP Dest port
537
Sets the IP address of the destination.
For IPv4, the address is entered in decimal notation using a
keypad. There are no restrictions on values entered but the
format must be correct, i.e: (
If three digits are entered in a field, a period will be
automatically added.
If only one or two digits are entered, you must enter a period
manually.
For IPv6, the address is entered in hexadecimal notation using a
keypad. There are no restrictions on value entered but the format
must be correct, i.e: (
0-FFFF
:
:
).
FFFF
0-FFFF
0-FFFF
If four digits are entered in a field, a colon will be automatically
added.
If only less than four digits are entered, you must enter a colon
manually.
Sets the IP version (IPv4 or IPv6) used for the Stream's
configuration.
A two-octet field in an Ethernet frame, used to indicate which
protocol is encapsulated in the payload.
The following menu items are available:
•
Internet Protocol, Version 4 (IPv4) 0x0800 (* default
value)
•
Internet Protocol, Version 6 (IPv6) 0x086DD
•
MPLS 0x8847
•
User defined (0x0 to FFFF)
Selects a User Data Protocol source port number (0 to 65535).
Selects a User Data Protocol destination port number (0 to
65535).
Port 0 is an officially reserved port in TCP/IP networking, and
should not be used.
.
.
.
0-255
0-255
0-255
0-255
:
:
:
0-FFFF
0-FFFF
0-FFFF
).
:
:
0-FFFF
0-
- Quick Links:
- Configuring the Ip Address
Hide quick links:
Advertisement
Table of Contents
