MPA_e_manual_D07-00-129P_RevA00
The RFC 2544 Tests screen contains the following functions:
•
Conf
•
Thru Put
•
Frame Loss
•
B2B Burst
•
Graph
The following list of tasks demonstrate how to configure and test each of the RFC-
2544 benchmark tests.
•
To Configure the RFC-2544 test settings see
•
To run an RFC-2544 Thru Put test see
•
To run an RFC-2544 Frame Loss test see
•
To run an RFC-2544 B2B Burst test see
RFC Tests - Configuration (Conf)
RFC testing provides a specific set of tests that can be used to measure and report the
performance characteristics of network devices. The RFC Tests Conf screen provides
the preliminary stream configuration settings. After these settings are made the user
selects the type of RFC test to initiate by choosing its tab along the left side of the RFC
Tests screen.
The following options appear on the Conf screen:
Option
Test
Dest Port
Description
Allows the user to switch between
Performance Standard Tests.
If this button is disabled, then only the selected
Performance Standard Test is currently available.
The destination Port setting is not supported on the MPA.
What are RFC 2544 Tests?
Throughput Testing
Frame Loss Testing
Back-to-Back Burst Testing
RFC-2544
Packet Tab
and
Y.1564
546