MPA_e_manual_D07-00-129P_RevA00
Getting Started
When the system is shipped from the factory, the AM4022 processor's default IP
•
Address is set to 192.168.0.10, with a Subnet Address of 255.255.255.0
The MCH controller module's default IP Address is set to 192.168.0.11, with a
•
Subnet Address of 255.255.255.0
The MCH's IP Address is only required if an External BITS/SETS chassis
o
clock is plugged into the RJ-48 Clock In/Out port
See
o
module's IP Address
The following methods can be used for changing the AM4022's IP Address:
•
USB flash drive
•
Remote GUI Client
VNC)
Note: Regardless which card type or method you use to change the MPA's IP Address,
you will need to reboot the MPA in order for the setting to take effect.
For assistance with changing the IP Address, contact
Changing the IP Address with a USB Flash Drive
The ability to change the MPA's IP Address with a USB flash drive (e.g., pen drive) is a
very simple and easy method of changing the IP Address, especially if you do not know
the MPA's current IP Address.
21
Changing the MCH module's IP Address
(preferred method)
(must currently be connected by the Remote GUI client or
for changing the MCH
Customer Tech
Support.