VeEX MPA User Manual page 613

MPA_e_manual_D07-00-129P_RevA00
Protocol Tabs
(Specifically for LAN/WAN Ethernet testing)
To determine if receiving equipment can detect an error on an incoming signal, you can
configure the system to insert specific errors and alarms into an Ethernet stream.
Note: Error insertion is disabled when IP Reflection Mode
is enabled.
To insert multiple errors:
1. Select the Packet tab.
2. Configure the
3. Enable traffic generation from the packet stream to be errored.
Important: Most error types require traffic generation to be
enabled on at least one packet stream.
4. Select Error / Alarm
5. Select Error Type
box.
6. Select Error Rate
dialog box.
7. Errors immediately start injecting into the packet stream when the error rate is
selected.
8. View various result statistics by selecting the
9. To stop error transmission select Error Rate and choose Off.
To insert a single error:
1. Repeat steps 1 through 5 above.
2. If you want to clear any previously collected data, select Restart from the
common function button at the bottom of the screen before inserting the error.
3. Select the Error Insert common function button at the bottom of the screen.
4. A single error will be inserted every time the Error Insert button is pressed.
613
Mode and desired Packet Stream
from the tabs along the left side of the Config Screen.
and choose an error type from the Select Error Type dialog
and choose an error rate from the Select Error Rate to Insert
settings.
Results function.