Mpm-10G Test Module Overview - VeEX MPA User Manual

MPA_e_manual_D07-00-129P_RevA00
•
Refer to Configuring the IP Address Overview
AM4022 Processor 's IP Address

MPM-10G Test Module Overview

The MPM-10G card (10G Multi-Protocol Module) supports interface rates ranging from
10Mbps up to 12Gbps.
The MPM-10G card has been designed to fit into any one of MPA's chassis test module
slots.
The MPM-10G card support two (2) fully independent test ports that can be equipped
with SFP/SFP+ optical modules and/or RJ-45 electrical SFP modules, for simultaneous
and independent testing or for loop-back testing from Port to Port.
Thus an MPA unit equipped with five (6) MPM-10G cards is capable of supporting a
total of twelve (12) independently configurable test ports (referred to as "Test Units" in
the GUI).
Both Port 1 and Port 2 on an MPM-10G card can be independently licensed and
controlled by the GUI or SCPI, and each Port can support independent protocol
processor tabs for OTN, SONET/SDH, and PACKET (for Ethernet, GFP and Fibre
Channel testing).
Each port's SFP and SPF+ "SFP Plus" modules are hot-swappable, which allows for
testing different Interfaces and wavelengths as needed.
Always verify that the laser module being inserted supports the Interface rate being
selected for test.
MPM-10G Test Module Overview
for details on changing the
98