VeEX MPA User Manual page 13

MPA_e_manual_D07-00-129P_RevA00
Getting Started
•
Eye Protection: Users should never stare into unterminated optical connectors or
fiber optic cables. In addition, fiber optic cables and optical connectors should
always be handled as if they were emitting laser light.
•
Installation: The unit is configured and shipped to mount into a 19-inch rack. A
minimum of four mounting screws are required to attach the unit to a rack's
mounting rails. Mounting screws (and/or clips) are the responsibility of the customer.
•
Field Service: This equipment is not intended to be serviced in the field. With the
exception of card swapping, all service is intended to be completed by VeEX.
For 110v/220v AC power supply module:
Turn off the unit's power switch when making power input connections. Refer to
Chapter 4 for the proper shutdown method before connecting or disconnecting the
DC power cord or swapping the DC power supply.
Use Proper Power Cord: To avoid fire hazard, only use the power cord specified
for this instrument. For use in North America, use a power cord (maximum six-
foot length) with a type SJT, 18 AWG, two-conductor with ground, IEC 60320-C13
connector on one end and a NEMA 5-15P connector on the other end.
For use outside of North America, use an HO5VV-F power cord with a 1-mm
two-conductor plus ground, IEC 60320 C-13 connector on one end, and a wall-
socket plug on the other end that is certified for use in the country of installation.
The entire cord set must be certified for use in the country of installation.
The AC Power Supply also supports a Self-Locking connector to prevent the
power cord from accidentally being unplugged.
13
2
,