VeEX MPA User Manual page 25

MPA_e_manual_D07-00-129P_RevA00
Getting Started
•
See images above for the location of the usb ports on both processor
cards.
8. Typically, within less than 30 seconds the file on the flash drive will automatically
reconfigure the IP Address and Reboot the MPA system.
•
For units with an AM4022 Processor, when the AM4022 Processor
reboots, you will see the LED's above the Ethernet ports, the USB port
and Display port (labeled 0 – 3) briefly turn Red for a couple of seconds,
and back to Green (or off), as the processor reboots.
For units with an SCM-210 card, the SCM-210's OLED display screen will
•
go blank and the green READY LED will turn off, indicating that the
system is rebooting.
Note: If after 30 to 45 seconds the MPA system does not reboot, this could
indicate one of the following conditions:
•
The IP Address configured in the mpa_ipconfig file is the same as that
already programmed on the MPA system
•
The mpa_ipconfig file was possibly renamed, or given a file extension
•
The mpa_ipconfig file was possibly saved to a sub-folder on the USB flash
drive, and not to the root directory
•
The USB flash drive was not recognized the first time was inserted and
may need to unplugged and plug it back in again.
•
The system may not have been fully booted prior to connecting the USB
flash drive, in which case wait a few minutes and try it again.
9. After the MPA begins the reboot process, disconnect the USB flash drive.
10. Wait for 4 to 5 minutes for the MPA system to finish booting up and verify that
you can now Ping and remotely connect to the processor's new IP Address.
11. For units with an SCM-210 card, the new IP Address is displayed on the OLED
screen and the MPA is fully booted and operational again when the green
READY LED illuminates.
25